Anchorage Heavy Duty
Adustment Instructions
Compression Adjustment
10
To finish ensure that the 2mm security grub screw on the reverse of the hinge
has been re-tightened and then replace the end cover cap
Note: The neutral setting should see the small line on the top of the hexagon
head facing the 9 o’clock position
9
8
Open the door so that you can see the reverse of the hinge. Using a 2mm Allen
key loosen off the pin security grub screw located at the rear of the hinge, this
will allow the compression pin to move freely.
With the door in the closed postion, remove the top cover cap by applying
pressure on the rear surface as shown opposite. The front of the cap should lift,
you may need to prise it gently to remove it.
Horizontal Adjustment
Height Adjustment
7
Remember to re-tighten the fixing screws once adjustment has been made and
replace the cover cap.
6
5
4
3
2
1
Once the desired height is achieved return the locking cam to the locked
position and replace cover cap.
Using the correct screwdriver slightly release the fixing screws taking pressure
off the adjustment bolt. Adjustment can be made using a 4mm Allen Key. Turn
the adjustment bolt clockwise to move the door away from the hinge side and
towards the lock side and anti-clockwise to move the door closer to the hinges.
With the door in the open position, locate the cover cap screw and remove it
using a 3mm Allen Key. Be careful whilst removing as this will release the main
cover cap and could potentially drop on the floor.
With the door in the closed position, remove the top cover cap by applying
pressure on the rear surface as shown opposite. The front of the cap should
lift, you may need to prise it gently to remove it.
Now viewing the hinge from above, use a 3mm allen key and release the
locking cam by turning anti-clockwise (highlighted in red).
Raise or lower the door by adjusting the height screw. Use a 3mm allen key
and turn clockwise to raise the door and anti-clockwise to lower the door.
Fab&Fix, The Moorings Business Park, Channel Way, Exhall, Coventry. CV6 6RH
Tel: 02476 585785 Fax: 02476 585786 Email: [email protected]
www.erahomesecurity.com
Un-Locked
Locked
Locking Cam
3mm Allen Key
Height screw
