Automotive
Used in older-model cars, glass tube fuses today are found primarily
in automotive accessory applications. The expansive Bussmann
series line of glass fuses includes many types and sizes in addition
to those listed in this catalog. Call Eaton for more product details if
you have requirements which are not covered here.
Appliances and consumer electronics
Glass and ceramic tube fuses are often used to protect appliances
and consumer electronics. As electronic equipment becomes
smaller, the circuits and components become more delicate and
easily damaged. Fuses are the preferred method of protection due
to their accuracy, small size and reliability. Fuses are available in a
wide variety of amp ratings to provide precise protection. Generally,
two sizes of user-replaceable fuses are found: the 1/4” x 1-1/4” and
5x20 mm. Each is available in a variety of volt and amp ratings.
Fuse types
There are two basic types of fuses available for appliances and
consumer electronics: fast-acting or time-delay. Any replacement
fuse must match the one it’s replacing. In general, fast-acting fuses
are a single strand of wire or strip of metal. Time-delay fuses usually
have a coiled wire, a thick element wrapped in wire, or a spring.
Most electronic fuses will have the voltage and amp rating stamped
on the end cap. The type of fuse can generally be visually identified.
Also, owner’s manuals will have the correct replacement fuse
generically identified. For example: “Use a 2 amp, time-delay, 250
volt fuse.”
Glass and ceramic tube fuse sizes
Glass and ceramic tube fuses
Glass and ceramic tube fuse sizes
Both glass and ceramic tube fuses vary by diameter and length. The
chart below provides a visual reference for the various sizes of the
Bussmann series fuse families. Images are shown to scale.
Fuse selection criteria
•
For electronic/electrical applications, fuses must be rated at 125 V
or better.
•
Voltage must match or exceed the fuse being replaced (125 V for
household current; 12 V for auto; 24 V for heavy duty).
•
Fuses must match required fuse characteristic – either fast-acting
or time-delay.
•
Amp rating must match that of the original fuse.
A note on voltage rating
All fuses have a voltage rating. To maintain safety, this voltage rating
should not be exceeded in application, although it is acceptable to
use a higher voltage rated fuse in a lower voltage application. For
example: A fuse rated for 125 volts is appropriate in household (110
V) or automotive (12 V), while a fuse rated for 32 volts is appropriate
for automotive (12 V), but not for household (125 V). Always replace
a fuse with one of the same or higher voltage rating.
See page 54 for specifications.
5 x 20 mm
GDA
GDB
GDC
GMA
GMC
GMD
1⁄4” x 5⁄8”
AGA
SFE-4
1⁄4” x 3⁄4”
SFE-6
1⁄4” x 7⁄8”
AWG
SFE-7-1/2
SFE-9
1⁄4” x 31⁄32”
GBC
1⁄4” x 1”
AGX
1⁄4” x 1-1⁄16”
SFE-14
1⁄4” x 1-1⁄4”
ABC
AGC
GBB
SFE-20
MDA
MDL
MDQ
1⁄4” x 1-7⁄16”
SFE-30
13⁄32” x 1-1⁄2”
AGU
AGU_GP
1/4" x 1-7/8
GMF*
* Mounts in HLR in-line holder, see page 14.
39
For product information and data sheets, visit Eaton.com/BussmannConsumer